1001 Worktop Jigīut in general, the stability of the cut depends upon the guide mechanism of the saw, and a three point guide is better than two point or single point. I can't speak to the diffuculty you're having with that particular model, as I haven't used it.įuseau horaire: GMT +1.,21h25 #2 jassou Super Membre Inscrit mars 2013 Pays France Rgion 31-Haute-Garonne Ville Toulouse Messages 51 Merci 7 Remerci: 9 fois en 4 mess. If there is metal in the wall, you usually do NOT want to cut that.!! I suggest cutting the drywall side first and see that there is nothing in the wall that you do not want to cut!! The metal blade can cut wood, no worries. HOWEVER, Consider using and possibly distroying a WOOD blade. Worktop jig 700 ♦ for right and left standard 90° and 45° joints ♦ for recesses for worktop connecting bolt ♦ cuts worktops from 400mm to. Undermount Sink JigsĪdobe ultra cs3 virtual sets. In terms of metal and wood, the blade itself determines that. The allen usually backs off a clamp that holds the blade. The extra brushes would likely be for the motor, and not used until the saw has LOTS of miles on it. I suggest tryinng it on a scrap piece of wood to make sure the distance is exact and the profile being cut doesnt need adjusted Posted on Dec 19, 2009. Set the straight edge that distance from the front of your top. You only need the distance from the roller on your bit to the back endge of the router fence.

Setting up a jig take time and if you are only making a straight cut then put a straight edge along your top and clamp it down. 288 Answers SOURCE: i have this router and it is the nicest one i have ever used.

Howdens worktop jig manual